SmartWinch Deceleration Rate Adjustment
Signal Line Switch Method
For D revision 2 models when using 2.4GHz radios
Before starting
- Winch is OFF
- Winch connected to Signal Line Switch.
- Signal Line Switch connected to receiver (Rx)
- Signal Line Switch OFF
- Transmitter (Tx) ON
- End points should be calibrated to this Tx previously for best results
Procedure
- Move Tx stick close hauled for fastest rate, full out for slowest or any intermediate position as desired.
- Turn the winch on and wait 13 seconds till the 3 rising tones then turn Signal Line Switch ON immediately (within 2 seconds).
- Turn Signal Line Switch OFF.
At this point 2 quick beeps will sound indicating the new setting has been saved.
- Turn winch OFF.
Note: This procedure can be performed as often as you like. There are no special requirements for deleting old settings before performing the procedure. Old settings are automatically replaced when new settings are made.